DTC P1E51-00

DTC P1E51-00  : Tandem Motor Cylinder Gearbox Mechanical Linkage Failure

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (Electric servo brake)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTCs with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

   -4. Wait 10 seconds or more without pressing the brake pedal.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   P1E51-00 Tandem Motor Cylinder Gearbox Mechanical Linkage Failure

   Is DTC P1E51-00 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

2. Tandem motor cylinder check

   -1. Turn the vehicle to the OFF (LOCK) mode with driver's door open.

   -2. Wait for 3 minutes.

   NOTE:  Do not close the driver's door.

   -3. Inspect the tandem motor cylinder .

   Is related parts damaged?

   YES 

   Replace the gearbox or the motor .

   NO 

   Check for loose terminals and poor connections in the electric servo brake control unit 22P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the electric servo brake control unit/pedal feel simulator .