DTC P1E32-00, P1E33-00, P1E34-00
DTC P1E32-00 : Master Cylinder Cut Valve Stuck OFF (Stuck Open)
DTC P1E33-00 : Master Cylinder Cut Valve Incorrect Operation
DTC P1E34-00 : Master Cylinder Cut Valve Stuck ON (Stuck Close)
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| P1E32-00 Master Cylinder Cut Valve Stuck OFF (Stuck Open) | ||
| P1E33-00 Master Cylinder Cut Valve Incorrect Operation | ||
| P1E34-00 Master Cylinder Cut Valve Stuck ON (Stuck Close) |
DTC (Electric servo brake)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTCs with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Wait 1 second or more without pressing the brake pedal.
-5. Press the brake pedal several times.
-6. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame P1E32-00 Master Cylinder Cut Valve Stuck OFF (Stuck Open) P1E33-00 Master Cylinder Cut Valve Incorrect Operation P1E34-00 Master Cylinder Cut Valve Stuck ON (Stuck Close) Is DTC P1E32-00, P1E33-00, or P1E34-00 indicated?
YES
The failure is duplicated. Check for loose terminals and poor connections in the electric servo brake control unit 22P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the electric servo brake control unit/pedal feel simulator .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.