Electric Parking Brake System Symptom Troubleshooting - Brake system indicator (red) does not go off

WARNING: This page is about a different variant/trim than selected.

DTC check

-1. Turn the vehicle to the ON mode.

-2. Check for DTCs with the HDS.

DTC Description	DTC

Is DTC indicated?

YES

Go to indicated DTC's troubleshooting.

Go to step 2.

Gauge control module operation check
-1. Do the gauge control module self-diagnostic function .

Is the gauge control module OK?

YES

Go to step 3.

NO

Replace the gauge control module .

Shorted wire check (PARK_LAMP line)

-1. Turn the vehicle to the OFF (LOCK) mode.

-2. Disconnect the following connectors.

VSA modulator-control unit 46P connector

Gauge control module connector A (32P)

-3. Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
	VSA modulator-control unit 46P connector: disconnected
	Gauge control module connector A (32P): disconnected
Test point 1	VSA modulator-control unit 46P connector No. 29
Test point 2	Body ground

Is there 1 MΩ or more?

YES

The PARK_LAMP wire is OK. Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

Repair a short to body ground in the wire between the VSA modulator-control unit and the gauge control module.