VTC Position Learn Procedure: Procedure
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Clearing the DTCs with the HDS does not require you to do this procedure.
- The PCM memorizes the learning status in its memory after passed an hour from turning the vehicle to the OFF (LOCK) mode. If you need to disconnect the 12 volt battery terminals before memorizing the learning status in the PCM, jump the SCS line with the HDS, and wait 60 seconds, then disconnect the 12 volt battery terminals.
- HDS - Connect
- VTC Position - Learn
1. Select the PGM-FI System with the HDS. 2. Select E-VTC LEARNING in the ADJUSTMENT with the HDS, and follow the screen prompts.
3. Turn the vehicle to the OFF (LOCK) mode.
4. Jump the SCS line with the HDS.
5. Wait 60 seconds, and exit the SCS mode with the HDS.