Throttle Body Carbon Accumulation Check: Test
WARNING: This page is about a different variant/trim than selected.
- HDS - Connect
- Throttle Body - Test
1. Enter the maintenance mode and start the engine 2. Hold the engine speed at 3000 RPM without load (in P or N) until the radiator fan comes on, then let it idle.
3. Select the PGM-FI System with the HDS.
4. Check the SOC in the DATA LIST with the HDS. If the reading is below 35%, keep idling until the SOC reaches 35%.
5. Check the REL TP SENSOR in the DATA LIST with the HDS. The reading should be below 2.97°. If it is not, clean the throttle body
.