DTC P2583-92

DTC P2583-92  : CMBS or FCW Over Working

NOTE: 

• Before you troubleshoot, review the general troubleshooting information .
• This DTC is recorded when the CMBS is activated five times in a single vehicle ON mode cycle.
• If this DTC is recorded, the CMBS function does not return to normal until the DTC is cleared with the HDS.
• If this DTC is recorded, the following is suspected:
• • The vehicle is responding to road signs, sign boards, guardrail, etc. installed along the road frequently depending on the surrounding environment.
  • The millimeter wave radar is installed improperly and close-range obstacles are detected frequently.
  • The millimeter wave radar installing portion is deformed by a minor collision or strong impact.
  • The beam axis of the millimeter wave radar is out of alignment due to abnormal wheel alignment, abnormal tire pressure, etc.
  • The CMBS is activated several times in a row intentionally by the driver.
• After inspecting, repairing, or adjusting a possible cause of the failure, be sure to perform millimeter wave radar aiming . If the DTC cannot be deleted after millimeter wave radar aiming, replace the millimeter wave radar .
• The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index .

DTC (IDAS)

1. Millimeter wave radar installation check

   -1. Remove the front bumper .

   -2. Check that the millimeter wave radar and radar bracket are installed properly and check them for deformation and damage.

   Are the millimeter wave radar and the radar bracket installed properly, and/or is there any no damage?

   YES 

   Go to step 2.

   NO 

   Repair or replace faulty parts, then aim the millimeter wave radar .

2. Millimeter wave radar check (aiming)

   -1. Install the front bumper .

   -2. Aim the millimeter wave radar .

   -3. Turn the vehicle to the ON mode.

   -4. Clear the DTC with the HDS.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC
   P2583-92 CMBS or FCW Over Working

   Is DTC P2583-92 indicated?

   YES 

   If the millimeter wave radar is installed properly but the DTC is recorded again after millimeter wave radar aiming, replace the millimeter wave radar .

   NO 

   The system is OK at this time.