DTC B2A60-54, P2583-54

DTC B2A60-54  : Static Camera Aiming Incomplete

DTC P2583-54  : Millimeter Wave Radar Aiming Incomplete

NOTE: 

• Before you troubleshoot, review the general troubleshooting information .
• These DTCs are recorded when aiming is not performed or aiming is not successfully completed.
• If a DTC is recorded again after it is cleared with the HDS, perform the aiming procedure below:
• • B2A60-54: Aim the multipurpose camera .
  • P2583-54: Aim the millimeter wave radar .
• The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index .

DTC (IDAS)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Turn the vehicle to the ON mode, then wait for at least 6 seconds.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC
   B2A60-54 Static Camera Aiming Incomplete
   P2583-54 Millimeter Wave Radar Aiming Incomplete

   Is DTC B2A60-54 or P2583-54 indicated?

   YES 

   The failure is duplicated. Aiming is incomplete. Aim the millimeter wave radar or the multipurpose camera .

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .