How to End a Troubleshooting Session (required after any troubleshooting)

WARNING: This page is about a different variant/trim than selected.

2. Turn the vehicle to the OFF (LOCK) mode.

3. Disconnect the HDS from the DLC.

4. Enter the maintenance mode, then start the engine

Hold the engine speed at 3, 000 rpm without load (in P or N position/mode) until the cooling fan comes on, then let it idle.

5. To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 44 mph (70 km/h) or under the same conditions as those indicated by the freeze data.