DTC P0130
DTC P0130 : A/F Sensor (Sensor 1) Out of Range
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0130 A/F Sensor (Sensor 1) Out of Range |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Enter the maintenance mode, then start the engine .
-4. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
-5. Monitor the OBD STATUS for DTC P0130 in the DTCs MENU with the HDS.
DTC Description OBD STATUS P0130 A/F Sensor (Sensor 1) Out of Range Does the HDS indicate FAILED?
YES
Replace the A/F sensor (Sensor 1) .
NO
If the HDS indicates PASSED, there is an intermittent failure and the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot . If the HDS indicates EXECUTING, keep idling until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 1-3 on this step and recheck.