DTC P1DEA (1018)
DTC P1DEA : VCU V0 Voltage Control Failure
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P1DEA VCU V0 Voltage Control Failure |
DTC (Electric Powertrain)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Raise the vehicle on a lift .
-5. Turn the vehicle to the READY TO DRIVE mode.
-6. Position to D, and test-drive at 50 mph (80 km/h) or more for 1 minute.
NOTE: Do not apply the brake hard when working on a running vehicle on a lift. It may cause some damage to the drive-line.
-7. Monitor the OBD STATUS for DTC P1DEA in the DTCs MENU with the HDS.
DTC Description OBD STATUS P1DEA VCU V0 Voltage Control Failure Does the HDS indicate FAILED?
YES
NO
If the HDS indicates PASSED, the system is OK at this time but has an intermittent failure. If the HDS indicates NOT COMPLETED, keep test-driving until an indication comes on. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.