DTC P1DA4 (486)

WARNING: This page is about a different variant/trim than selected.

DTC P1DA4 : VCU Inverter Short

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P1DA4 VCU Inverter Short

DTC (Electric Powertrain)

Problem verification

-1. Turn the vehicle to the ON mode.

-2. Clear the DTC with the HDS.

-3. Turn the vehicle to the OFF (LOCK) mode.

-4. Raise the vehicle on a lift .

-5. Turn the vehicle to the READY TO DRIVE mode.

-6. Position to D, and test-drive at 50 mph (80 km/h) or more for 1 minute.

NOTE: Do not apply the brake hard when working on a running vehicle on a lift. It may cause some damage to the drive-line.

-7. Monitor the OBD STATUS for DTC P1DA4 in the DTCs MENU with the HDS.

DTC Description	OBD STATUS
P1DA4 VCU Inverter Short

Does the HDS indicate FAILED?

YES

Replace the PCU .

If the HDS indicates PASSED, the system is OK at this time but has an intermittent failure. If the HDS indicates NOT COMPLETED, keep test-driving until an indication comes on. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.