DTC B0050-F0 (VSA Control Unit)
WARNING: This page is about a different variant/trim than selected.
DTC B0050-F0 : (Driver's Seat Belt Buckle Switch Malfunction)
NOTE
- Initial Diagnosis:
The initial on-board diagnosis occurs right after the vehicle condition is turned to the ON mode, and the ABS/VSA indicator comes on, and continues until the indicator goes off.
- Regular Diagnosis:
The regular on-board diagnosis begins right after the ABS/VSA indicator goes off, and it continues until the vehicle condition is turned to the OFF (LOCK) mode.
- Review "How to troubleshoot the VSA system" before doing the DTC troubleshooting procedure.
- Test-drive the vehicle according to local traffic conditions and regulations. Do not test-drive on a lift unless specified.
- The possible causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
| Confirmation Procedure | Basic Condition:
With the Driving Pattern:
|
| Execution | Regular Diagnosis |
| Duration | About 1 second |
| DTC Type |
|
| Fail Safe Action |
|
| Possible Cause |
|