DTC P0BE6 (86)

WARNING: This page is about a different variant/trim than selected.

DTC P0BE6 : Traction Motor Phase U Current Sensor Circuit Range/Performance

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
P0BE6 Traction Motor Phase U Current Sensor Circuit Range/Performance

DTC (Electric Powertrain)

Problem verification

-1. Turn the vehicle to the ON mode.

-2. Clear the DTC with the HDS.

-3. Turn the vehicle to the OFF (LOCK) mode.

-4. Turn the vehicle to the ON mode.

-5. Monitor the OBD STATUS for DTC P0BE6 in the DTCs MENU with the HDS.

DTC Description	OBD STATUS
P0BE6 Traction Motor Phase U Current Sensor Circuit Range/Performance

Does the HDS indicate FAILED?

YES

Replace the PCU .

If the HDS indicates PASSED, the system is OK at this time but has an intermittent failure. If the HDS indicates NOT COMPLETED, keep the vehicle in the ON mode until an indication comes on. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.