DTC P0BCC (287)

DTC P0BCC  : Generator Motor Inverter Temperature Sensor Circuit

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC (Electric Powertrain)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Raise the vehicle on a lift .

   -5. Turn the vehicle to READY TO DRIVE mode.

   -6. Test-drive the vehicle under these conditions for 1 minute:

   • Position to D, but do not operate the accelerator pedal.

     NOTE:  Do not apply the brake hard when working on a running vehicle on a lift. It may cause some damage to the drive-line.

   • Motor Speed (GEN) is more than 1000 RPM for 10 seconds.

   Signal	Current conditions
   	Values	Unit
   Motor Speed (GEN)

   -7. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0BCC Generator Motor Inverter Temperature Sensor Circuit

   Is DTC P0BCC indicated?

   YES 

   Replace the PCU .

   NO 

   Intermittent failure. The system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.