DTC P0A90 (1040)
DTC P0A90 : Traction Motor Performance
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0A90 Traction Motor Performance |
DTC (Electric Powertrain)
- DTC check
-1. Turn the vehicle to the ON mode.
-2. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame DTC (Electric Powertrain)
Are DTC P0A90 and any other DTCs indicated at the same time?
YES
Go to the indicated DTC's troubleshooting.
NO
Go to step 2.
- Problem verification
-1. Clear the DTC with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode.
-3. Turn the vehicle to the ON mode.
-4. Turn the EV switch OFF.
-5. Turn the vehicle to the READY TO DRIVE mode.
-6. Position to D, and test-drive at 34 mph (55 km/h) for 5 seconds.
-7. Monitor the OBD STATUS for DTC P0A90 in the DTCs MENU with the HDS.
DTC Description OBD STATUS P0A90 Traction Motor Performance Does the HDS indicate FAILED?
YES
Faulty traction motor. Replace the transmission (e-CVT) assembly .
NO
If the HDS indicates PASSED, the system is OK at this time but has an intermittent failure. If the HDS indicates NOT COMPLETED, keep the vehicle in the ON mode until an indication comes on. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.