DTC P0A2B (359)

DTC P0A2B  : Traction Motor Temperature Sensor Circuit Range/Performance

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC (Electric Powertrain)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Turn the vehicle to the ON mode.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0A2B Traction Motor Temperature Sensor Circuit Range/Performance

   Is DTC P0A2B indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure. The system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

2. Determine possible failure area (traction motor temperature sensor, others)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Disconnect the following connector.

   Motor temperature sensor 6P connector

   -3. Turn the vehicle to the ON mode.

   -4. Check the parameter(s) below with the HDS.

   Signal	Threshold		Current conditions
   	Values	Unit	Values	Unit
   Motor Temperature Sensor Voltage (TRC)	More than 4.83	V

   Does the current condition(s) match the threshold?

   YES 

   Faulty traction motor temperature sensor. Replace the transmission (e-CVT) assembly .

   NO 

   Replace the PCU .