DTC C0061-54, C0062-54, C0063-54
DTC C0061-54 : Lateral Acceleration Sensor Calibration Incomplete
DTC C0062-54 : Longitudinal Acceleration Sensor Neutral Position Not Learned/Calibration Incomplete
DTC C0063-54 : Yaw Rate Sensor Calibration Incomplete
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC |
|---|---|
| C0061-54 Lateral Acceleration Sensor Calibration Incomplete | |
| C0062-54 Longitudinal Acceleration Sensor Neutral Position Not Learned/Calibration Incomplete | |
| C0063-54 Yaw Rate Sensor Calibration Incomplete |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Check for DTCs with the HDS.
DTC Description DTC C0061-54 Lateral Acceleration Sensor Calibration Incomplete C0062-54 Longitudinal Acceleration Sensor Neutral Position Not Learned/Calibration Incomplete C0063-54 Yaw Rate Sensor Calibration Incomplete Is DTC C0061-54, C0062-54, or C0063-54 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .
- SRS unit check
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Substitute a known-good SRS unit .
-3. Turn the vehicle to the ON mode.
-4. Clear the DTC with the HDS.
-5. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-6. Check for DTCs with the HDS.
DTC Description DTC C0061-54 Lateral Acceleration Sensor Calibration Incomplete C0062-54 Longitudinal Acceleration Sensor Neutral Position Not Learned/Calibration Incomplete C0063-54 Yaw Rate Sensor Calibration Incomplete Is DTC C0061-54, C0062-54, or C0063-54 indicated?
YES
Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .
NO