DTC C0051-62, C0051-96
DTC C0051-62 : Steering Angle Sensor Failure (Signal Compare Failure)
DTC C0051-96 : Steering Angle Sensor Failure (Sensor Detects Internal Failure)
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC |
|---|---|
| C0051-62 Steering Angle Sensor Failure (Signal Compare Failure) | |
| C0051-96 Steering Angle Sensor Failure (Sensor Detects Internal Failure) |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the READY TO DRIVE mode.
-4. Test-drive the vehicle under these conditions:
- Vehicle speed at 45 mph (72 km/h) or more
- Change lanes for a few times
NOTE:
- Drive the vehicle on the road, not on a lift.
- Be careful of the surrounding traffic conditions.
-5. Check for DTCs with the HDS.
DTC Description DTC C0051-62 Steering Angle Sensor Failure (Signal Compare Failure) C0051-96 Steering Angle Sensor Failure (Sensor Detects Internal Failure) Is DTC C0051-62 or C0051-96 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .
- DTC check (EPS control unit)
-1. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame Is DTC indicated?
YES
Go to indicated DTC's troubleshooting.
NO
Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .