DTC C0044-49
WARNING: This page is about a different variant/trim than selected.
DTC C0044-49 : Master Cylinder Pressure Sensor Failure (Internal Circuit Failure)
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC |
|---|---|
| C0044-49 Master Cylinder Pressure Sensor Failure (Internal Circuit Failure) |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Check for DTCs with the HDS.
DTC Description DTC C0044-49 Master Cylinder Pressure Sensor Failure (Internal Circuit Failure) Is DTC C0044-49 indicated?
YES
The failure is duplicated. Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .