DTC B0050-F0 (VSA Control Unit)
WARNING: This page is about a different variant/trim than selected.
DTC B0050-F0 : (Driver's Seat Belt Buckle Switch Malfunction)
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC |
|---|---|
| B0050-F0 (Driver's Seat Belt Buckle Switch Malfunction) |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode, then wait for a few seconds or more.
-5. Check for DTCs with the HDS.
DTC Description DTC B0050-F0 (Driver's Seat Belt Buckle Switch Malfunction) Is DTC B0050-F0 indicated?
YES
The failure is duplicated. Go to SRS troubleshooting .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .