How to End a Troubleshooting Session (required after any troubleshooting)

WARNING: This page is about a different variant/trim than selected.

2. Turn the vehicle to the READY TO DRIVE mode.

3. Clear the DTC with the HDS.

4. Turn the vehicle to the OFF (LOCK) mode.

5. Wait for 60 seconds.

6. Turn the vehicle to the READY TO DRIVE mode.

7. Check for DTCs with the HDS.

NOTE: Test-drive the vehicle if necessary.

8. Make sure there is no DTC found and no warning indication on the gauge.

9. Turn the vehicle to the OFF (LOCK) mode, and disconnect the HDS.