DTC P2138

DTC P2138  : APP Sensor A/B (TP Sensor D/E) Incorrect Voltage Correlation

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC (PGM-FI)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Press the accelerator pedal to the floor.

   -4. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC
   P2138 APP Sensor A/B (TP Sensor D/E) Incorrect Voltage Correlation

   Is DTC P2138 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the APP sensor and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .

2. Determine possible failure area (APP sensor, others)

   -1. Check the parameter(s) below with the HDS.

   Signal	Current conditions
   	Values	Unit
   APP Sensor A Voltage
   APP Sensor B Voltage

   Are they the same voltage?

   YES 

   Go to step 3.

   NO 

   Replace the accelerator pedal module .

3. Determine possible failure area (PCM, others)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Jump the SCS line with the HDS, and wait more than 1 minute.

   -3. Disconnect the following connector.

   PCM connector A (50P)

   -4. Measure the resistance between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	PCM connector A (50P): disconnected
   Test point 1	PCM connector A (50P) No. 32
   Test point 2	PCM connector A (50P) No. 34

   Is there 1 MΩ or more?

   YES 

   Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM .

   NO 

   Go to step 4.

4. Shorted wire check (APS1 line to APS2 line)

   -1. Disconnect the following connector.

   APP sensor 6P connector

   -2. Measure the resistance between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	PCM connector A (50P): disconnected
   	APP sensor 6P connector: disconnected
   Test point 1	PCM connector A (50P) No. 32
   Test point 2	PCM connector A (50P) No. 34

   Is there 1 MΩ or more?

   YES 

   The APS1 wire and the APS2 wire are OK. Replace the accelerator pedal module .

   NO 

   Repair a short in the APS1 wire to the APS2 wire between the PCM (A32, A34) and the APP sensor.