DTC P145E

DTC P145E  : EVAP System Purge Flow Malfunction 2

NOTE: 

• Before you troubleshoot, review the general troubleshooting information .
• If DTC P145E is indicated alone, do the troubleshooting for DTC P04AE and P04F1 using the on-board snapshot for P145E.
• If DTC P04AE, P04F1, and P145E are stored at the same time, check for a poor connection, a blockage, or damage at the EVAP canister purge line between EVAP canister purge valve 2 and the EVAP canister. Also check for a stuck closed EVAP canister purge valve 2.
• If any of the DTCs listed below are indicated at the same time as DTC P145E, troubleshoot those DTCs first, then recheck for P145E.

  P04AE, P04F1: EVAP system purge flow

DTC (PGM-FI)

1. DTC check

   -1. Turn the vehicle to the ON mode.

   -2. Select the EVAP TEST in the Function Test, then select the FUNCTION TEST with the HDS.

   EVAP TEST

   Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC
   P04AE EVAP System High Purge Flow Detected 2
   P04F1 EVAP System Low Purge Flow Detected
   P145E EVAP System Purge Flow Malfunction 2

   Are DTC P145E and P04AE or P04F1 indicated at the same time?

   YES 

   Go to the indicated DTC's troubleshooting.

   NO 

   Go to the troubleshooting for DTC P04AE  and DTC P04F1  using the on-board snapshot for DTC P145E.