DTC P043E, P043F
DTC P043E : EVAP Leak Check Module Standard Pressure Low
DTC P043F : EVAP Leak Check Module Standard Pressure High
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P043E EVAP Leak Check Module Standard Pressure Low | ||
| P043F EVAP Leak Check Module Standard Pressure High |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode.
-5. Select the EVAP TEST in the Function Test Menu, then select EVAP Leak Check Module Test with the HDS.
EVAP TEST
Is the result OK?
YES
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the EVAP leak check module and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .
NO
The failure is duplicated. Go to step 2.
- EVAP leak check module drain hose check
-1. Remove the EVAP leak check module and the EVAP canister filter , then check the blockage in the drain hoses and the EVAP canister filter.
Are the parts OK?
YES
Replace the EVAP leak check module .
NO
Remove the blockage from them, or replace the part(s) if needed.