LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2021 >> CR-V EX-L, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Exterior Trim / Components - Service Information (Hybrid)) >> Removal and Installation >> Washer Tube Removal and Installation >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

Front Side Washer 

  1. Front Bumper - Remove 
  2. Center Cowl Cover - Remove 
  3. Right Front Inner Fender - Remove 
  4. Front Door Sill Trim - Remove
  5. Kick Panel - Remove
  6. Washer Tubes - Remove

    NOTE:  Take care not to pinch the washer tubes. Check the washer operation.

    1. Remove the washer tube(s).

    GHH378801Courtesy of HONDA, U.S.A., INC.
  7. All Removed Parts - Install
    1. Install the parts in the reverse order of removal.

    Rear Side Washer 

  8. Right Rear Door Sill Trim - Remove
  9. Right Center Pillar Lower Trim - Remove
  10. Right Rear Side Trim Panel - Remove
  11. Right Quarter Pillar Trim - Remove
  12. Headliner - Remove
    1. Remove the headliner as needed .
  13. Tailgate Upper Trim Panel - Remove
  14. Tailgate Spoiler Trim - Remove 
  15. Washer Tubes - Remove

    NOTE:  Take care not to pinch the washer tubes. Check the washer operation.

    1. Remove the washer tube(s).

    GHH378802Courtesy of HONDA, U.S.A., INC.
  16. All Removed Parts - Install
    1. Install the parts in the reverse order of removal.