SRS Symptom Troubleshooting - SRS indicator does not come on
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed .
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
- Problem verification
-1. Turn the vehicle to the OFF (LOCK) mode, then wait for 10 seconds.
-2. Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then go off.
Does the SRS indicator come on for about 6 seconds and then go off?
YES
Intermittent failure, the vehicle is OK at this time.
NO
The failure is duplicated. Go to step 2.
- Gauge control module check
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Connect the HDS to the data link connector (DLC) .
-3. Turn the vehicle to the ON mode.
-4. Do the gauge control module self-diagnostic function .
Does the SRS indicator blinkΩ
YES
Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit .
NO