Removal and Installation: Notes

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: 

• Where icon is shown, for further information see below.
• When working on electronic components, make sure the work area is clean and dust free.
• Make sure your hands are clean and free of oils and grease.
• When the audio-navigation unit is replaced or disconnected, do the Map Matching. This part of the initialization matches the GPS coordinates with a road on the map screen. To do this part of the procedure, make sure that the navigation system displays a map, and drive the vehicle on a mapped road shown on the map screen. Do not enter a destination at this time. When the name of the current road you are driving on appears at the bottom of the screen, the entire procedure is complete.