DTC B00A0-54
WARNING: This page is about a different variant/trim than selected.
DTC B00A0-54 : Front Passenger's Weight Sensor not Calibrated
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed .
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
| DTC Description | DTC |
|---|---|
| B00A0-54 Front passenger's weight sensor not calibrated |
DTC (SRS)
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the ON mode, then wait for 10 seconds.
-3. Check for DTCs with the HDS.
DTC Description DTC B00A0-54 Front passenger's weight sensor not calibrated Is DTC B00A0-54 indicated?
YES
The failure is duplicated. Do the front passenger's weight sensor initialization .
NO
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.