DTC B0096-4A, B0096-92
WARNING: This page is about a different variant/trim than selected.
DTC B0096-4A, B0096-92 : Internal Failure of the Right Side Impact Sensor (first)
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed .
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
| DTC Description | DTC |
|---|---|
| B0096-4A Internal failure of the right side impact sensor (first) | |
| B0096-92 Internal failure of the right side impact sensor (first) |
DTC (SRS)
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the ON mode, then wait for 10 seconds.
-3. Check for DTCs with the HDS.
DTC Description DTC B0096-4A Internal failure of the right side impact sensor (first) B0096-92 Internal failure of the right side impact sensor (first) Is DTC B0096-4A or B0096-92 indicated?
YES
The failure is duplicated. Replace the right side impact sensor (first) , then clear the DTC, and retest. If the DTC is still present, check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit .
NO
Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.