DTC B1080

DTC B1080  : Power supply circuit (IG1 line) input error for Relay Control Module and MICU

NOTE:  If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .

DTC (Relay Control Module)

1. Problem verification

   -1. Clear the DTCs with the HDS.

   -2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.

   -3. Wait for at least 6 seconds.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC
   B1080 Power supply circuit (IG1 line) input error for Relay Control Module and MICU

   Is DTC B1080 indicated?

   YES 

   Repair an open or high resistance in the IG1_METER wire.

   NO 

   Intermittent failure, the system is OK at this time. Check for loose or poor connections.