DTC B2614, B2615, B2616, B2617

DTC B2614  : Rear 1st sensor failure

DTC B2615  : Rear 2nd sensor failure

DTC B2616  : Rear 3rd sensor failure

DTC B2617  : Rear 4th sensor failure

NOTE: 

• If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
• The connection order of the sensor is 1st -> 2nd -> 3rd -> 4th from the side near the control unit.

DTC (Parking and Back-Up Sensor Control Unit)

1. Problem verification

   -1. Clear the DTCs with the HDS.

   -2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.

   -3. Wait for at least 6 seconds.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC
   B2614 Rear 1st sensor failure
   B2615 Rear 2nd sensor failure
   B2616 Rear 3rd sensor failure
   B2617 Rear 4th sensor failure

   Are any DTCs indicated?

   YES 

   Refer to the DTC shown on the display, then replace the sensor based on the instructions (see table).

   DTC	Operation for transmitting control unit
   B2614	Left rear corner sensor
   B2615	Left rear center sensor
   B2616	Right rear center sensor

   DTC	Operation for transmitting control unit
   B2617	Right rear corner sensor

   NO 

   Intermittent failure, the system is OK at this time. Check for loose or poor connections.