DTC B1127

DTC B1127  : Driver's door lock key cylinder switch malfunction

NOTE:  If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .

DTC (Multiplex Control Unit, Door)

1. Problem verification (driver's door key cylinder switch in the neutral position)

   -1. Check the parameter(s) below with the HDS.

   Signal	Current conditions
   	Values	Unit
   Driver's Door Key Cylinder Switch(LOCK)
   Driver's Door Key Cylinder Switch(UNLOCK)

   Is either information indicator ON?

   YES 

   Go to step 4.

   NO 

   Go to step 2.

2. Problem verification (driver's door key cylinder switch in the lock position)

   -1. With the driver's door key cylinder in the lock position, check the parameter(s) below with the HDS.

   Signal	Current conditions
   	Values	Unit
   Driver's Door Key Cylinder Switch (LOCK)
   Driver's Door Key Cylinder Switch (UNLOCK)

   Are both information indicators ON?

   YES 

   Go to step 3.

   NO 

   Intermittent failure, the system is OK at this time.

3. Shorted wire check (DR_KEY_CYL_UNLOCK to DR_KEY_CYL_LOCK line)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Disconnect the following connector.

   Driver's door latch 10P connector

   -3. Connect terminals A and B with a jumper wire.

   Terminal A	Power window master switch 37P connector No. 7
   Terminal B	Body ground

   -4. Check the parameter(s) below with the HDS.

   Signal	Current conditions
   	Values	Unit
   Driver's Door Key Cylinder Switch (LOCK)
   Driver's Door Key Cylinder Switch (UNLOCK)

   Are both information indicators ON?

   YES 

   Repair a short between the wires.

   NO 

   The DR_KEY_CYL_UNLOCK to DR_KEY_CYL_LOCK wire is OK. Faulty driver's door key cylinder switch; replace the driver's door latch .

4. Determine possible failure area (driver's door latch, others)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Disconnect the following connector.

   Driver's door latch 10P connector

   -3. Check the parameter(s) below with the HDS.

   Signal	Current conditions
   	Values	Unit
   Driver's Door Key Cylinder Switch (LOCK)
   Driver's Door Key Cylinder Switch (UNLOCK)

   Is either information indicator ON?

   YES 

   Go to step 5.

   NO 

   Faulty driver's door key cylinder switch; replace the driver's door latch .

5. Shorted wire check (DR_KEY_CYL_UNLOCK, DR_KEY_CYL_LOCK lines)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Disconnect the following connector.

   Power window master switch 37P connector

   -3. Measure the resistance between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode Driver's door latch 10P connector: disconnected Power window master switch 37P connector: disconnected
   Test point 1	Power window master switch 37P connector No. 7
   Test point 2	Body ground

   Test point 1	Power window master switch 37P connector No. 8
   Test point 2	Body ground

   Is there 1.0 MΩ or more?

   YES 

   The DR_KEY_CYL_UNLOCK and DR_KEY_CYL_LOCK wires are OK. Replace the power window master switch ..

   NO 

   Repair a short to ground in the wire.