Electric Servo Brake System Sensor 0 (Zero) Position Memorization: Procedure

WARNING: This page is about a different variant/trim than selected.

The electric servo brake system sensor 0 (zero) position must be memorized whenever you do any of these actions:

Electric servo brake control unit/pedal feel simulator removal and installation
Brake pedal removal and installation
Electric servo brake control unit update
Brake pedal height adjustment

HDS - Connect

Sensor 0 (Zero) Position - Memorize

NOTE: If brake system indicator (amber) is blinking before this procedure, press the brake pedal hard while brake system indicator goes off.

1. In the BRAKE SYSTEM MENU of the HDS, select ELECTRIC SERVO BRAKE SYSTEM, select ADJUSTMENT MENU, then select SENSOR 0 (ZERO) POSITION MEMORIZATION.