Brake System Inspection and Test: Inspection
WARNING: This page is about a different variant/trim than selected.
- Brake System - Inspect
Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged.
Component Inspections:
Component Procedure Also check for Brake hoses Look for damage or signs of fluid leakage at: - Line joints and banjo bolt connections.
- Hoses and lines, also inspect for twisting or damage.
Bulging, twisted, or bent lines. Caliper Look for damage or signs of fluid leakage at: - Piston seals.
- Banjo bolt connections.
- Bleed screw.
Seized or sticking caliper pins. Tandem Motor Cylinder Look for damage or signs of fluid leakage at: - Reservoir, reservoir union, or tandem motor cylinder.
- Lines, reservoir hose, grommets, and their joints.
- Between slave cylinder and gearbox.
- Bleed screw.
Bulging seal at reservoir cap. This is a sign of fluid contamination. Pedal Feel Simulator Look for damage or signs of fluid leakage at: - Reservoir, reservoir union, or pedal feel simulator.
- Lines, reservoir hose, grommets, and their joints.
- Bleed screw.
Bulging seal at reservoir cap. This is a sign of fluid contamination. VSA modulator-control unit Look for damage or signs of fluid leakage at: - Line joints.
- Modulator-control unit.