DTC P1009 (1.5 L Engine)

DTC P1009  : VTC A Advance Malfunction

NOTE: 

• Before you troubleshoot, review the general troubleshooting information .
• If DTC P0341 is stored at the same time as DTC P1009, troubleshoot DTC P1009 first, then recheck for DTC P0341.
• If DTC P1009 set after replacing the VTC actuator, verify that the correct timing marks on the crank pulley were used.

DTC (PGM-FI)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Start the engine.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC
   P1009 VTC A Advance Malfunction

   Is DTC P1009 indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .

2. VTC oil control solenoid valve A operation check

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Test VTC oil control solenoid valve A .

   Is the solenoid valve OK?

   YES 

   Go to step 3.

   NO 

   Replace VTC oil control solenoid valve A .

3. VTC actuator A check

   -1. Inspect VTC actuator A .

   Is the actuator OK?

   YES 

   Check the VTC system oil passages and clean them if needed.

   NO 

   Replace VTC actuator A .