DTC P0797 (CVT (ECM/Pcm))

DTC P0797  : Pressure Control Solenoid Valve C Stuck ON

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (CVT)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. With the brake pedal pressed, do the following operational mode of the shift lever five times:

   • Start the engine in P position/mode.
   • Shift the transmission to N position/mode, then to D position/mode.
   • Shift the transmission to N position/mode, and wait for at least 2 seconds.
   • Shift the transmission to D position/mode.

   -4. Turn the engine off. Repeat the shift lever operational mode in step 1-3 five times.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0797 Pressure Control Solenoid Valve C Stuck ON

   Is DTC P0797 indicated?

   YES 

   The failure is duplicated. Faulty CVT clutch pressure control solenoid valve. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.