DTC P0777 (CVT (ECM/Pcm))
DTC P0777 : CVT Driven Pulley Pressure Control Solenoid Valve Stuck ON
NOTE: Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0777 CVT Driven Pulley Pressure Control Solenoid Valve Stuck ON |
DTC (CVT)
- DTC check
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Test-drive the vehicle in D position/mode until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the vehicle. Then accelerate from a stop at full throttle in D position/mode until the vehicle speed reaches 37 mph (60 km/h).
-4. Turn the engine off. Repeat the test-drive in step 1-3 again.
-5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0777 CVT Driven Pulley Pressure Control Solenoid Valve Stuck ON Is DTC P0777 indicated?
YES
The failure is duplicated. Faulty CVT driven pulley pressure control solenoid valve. Replace the valve body assembly .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.