DTC P0746 (CVT (ECM/Pcm))

DTC P0746  : CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (CVT)

1. DTC check

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Test-drive the vehicle in D position/mode until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the vehicle. Then accelerate from a stop at full throttle in D position/mode until the vehicle speed reaches 37 mph (60 km/h).

   -4. Turn the engine off. Repeat the test-drive in step 1-3 again.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0746 CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF

   Is DTC P0746 indicated?

   YES 

   The failure is duplicated. Faulty CVT drive pulley pressure control solenoid valve. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.