DTC P05AF (1.5 L Engine)

DTC P05AF  : Shutter Grille Assembly (Lower) Malfunction

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC (PGM-FI)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Start the engine, then let it idle.

   -5. Check the parameter (s) below with the HDS.

   Signal	Threshold		Current conditions
   	Values	Unit	Values	Unit
   Lower shutter grill block error	Normal
   Lower shutter grill initial learning error	Completed

   Do the current condition (s) match the threshold?

   YES 

   Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the shutter grille (lower) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .

   NO 

   Go to step 2.

2. Shutter grille condition check

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Inspect the lower shutter grille for any damage or foreign materials caught in the shutter assembly.

   Is the shutter grille OK?

   YES 

   Go to step 3.

   NO 

   Remove the foreign material or replace the shutter grille (lower) .

3. Shorted wire check (+B FR FOG/VMP line)

   -1. Check the following fuse.

   Fuse

   No. A22

   Is the fuse OK?

   YES 

   Go to step 4.

   NO 

   Repair a short in the +B FR FOG/VMP wire between shutter grille (lower) and the No. A22 fuse. Also replace the No. A22 fuse.

4. Open wire check (+B FR FOG/VMP line)

   -1. Disconnect the following connector.

   Shutter grille (lower) 4P connector

   -2. Measure the voltage between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Shutter grille (lower) 4P connector: disconnected
   Test point 1	Shutter grille (lower) 4P connector (female terminals) No. 1:
   Test point 2	Body ground

   Courtesy of HONDA, U.S.A., INC.

   Is there battery voltage?

   YES 

   Go to step 5.

   NO 

   Repair an open in the +B FR FOG/VMP wire between the shutter grille (lower) and the No. A22 fuse .

5. Open wire check (GND line)

   -1. Measure the resistance between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Shutter grille (lower) 4P connector: disconnected
   Test point 1	Shutter grille (lower) 4P connector (female terminals) No. 4:
   Test point 2	Body ground

   Courtesy of HONDA, U.S.A., INC.

   Is there 1.0 Ω or less?

   YES 

   Replace the shutter grille (lower) .

   NO 

   Repair an open in the GND wire between the shutter grille (lower) and G251.