DTC P0130 (2.4 L Engine) (2018 2019)

DTC P0130  : A/F Sensor (Sensor 1) Out of Range

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC (PGM-FI)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Start the engine.

   -4. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

   -5. Monitor the OBD STATUS for P0130 with the HDS.

   DTC Description	OBD STATUS
   P0130 A/F Sensor (Sensor 1) Out of Range

   Does the HDS indicate FAILED?

   YES 

   Replace the A/F sensor (Sensor 1) .

   NO 

   If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F Sensor (Sensor 1) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot . If the HDS indicates EXECUTING, keep idling until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 1-4 and recheck.