LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2021 >> CR-V EX-L, AWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System - DTC Diagnostics (P0010 - P0141) (Except Hybrid) >> DTC Troubleshooting >> DTC P0035 (1.5 L Engine)

DTC P0035 (1.5 L Engine)

DTC P0035  : Turbocharger Bypass Control Solenoid Valve Circuit High Voltage

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC Description Confirmed DTC Pending DTC
P0035 Turbocharger Bypass Control Solenoid Valve Circuit High Voltage    

DTC (PGM-FI)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Turn the vehicle to the OFF (LOCK) mode.

    -4. Turn the vehicle to the ON mode.

    -5. Do the ABV TEST in the INSPECTION MENU with the HDS.

    ABV TEST

    Monitor the OBD STATUS for DTC P0035 in the DTCs MENU with the HDS.

    DTC Description OBD STATUS
    P0035 Turbocharger Bypass Control Solenoid Valve Circuit High Voltage  

    Does the HDS indicate FAILED?

    YES 

    Go to step 2.

    NO 

    If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the turbocharger bypass control solenoid valve and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot . If the HDS indicates NOT COMPLETED, go to step 1-5 and recheck.

  2. Open wire check (ABV line)

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Jump the SCS line with the HDS, and wait more than 1 minute.

    -3. Disconnect the following connectors.

    Turbocharger bypass control solenoid valve 2P connector
    PCM connector E (80P)

    -4. Check for continuity between test points 1 and 2.

    Test condition Vehicle OFF (LOCK) mode
      Turbocharger bypass control solenoid valve 2P connector: disconnected
      PCM connector E (80P): disconnected
    Test point 1 Turbocharger bypass control solenoid valve 2P connector (female terminals) No. 1:
    Test point 2 PCM connector E (80P) No. 79
    GHH424883Courtesy of HONDA, U.S.A., INC.

    Is there continuity?

    YES 

    The ABV wire is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or substitute a known-good PCM .

    NO 

    Repair an open in the ABV wire between the PCM (E79) and the turbocharger bypass control solenoid valve.