Removal and Installation

1 

Fig 1: Starter Bolts With Torque Specifications

Courtesy of HONDA, U.S.A., INC.

Torque: N.m (kgf.m, lbf.ft)

1. 12 Volt Battery Terminal - Disconnect
2. Engine Undercover - Remove
3. Exhaust Pipe A - Remove
4. Intake Manifold Bracket - Remove
5. Starter - Remove
6. All Removed Parts - Install

   1. Install the parts in the reverse order of removal. NOTE: Make sure the crimped side of the ring terminal faces away from the starter when you connect the positive starter cable.