DTC B1051

DTC B1051  : Relay control module internal (CPU) error

NOTE:  If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .

DTC (Relay Control Module)

1. Problem verification

   -1. Clear the DTCs with the HDS.

   -2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.

   -3. Wait for at least 6 seconds.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC
   B1051 Relay control module internal (CPU) error

   Is DTC B1051 indicated?

   YES 

   Replace the relay control module .

   NO 

   Intermittent failure, the system is OK at this time. Check for loose or poor connections.