Removal and Installation
NOTE:
Where icon is shown, for further information continue to the information below.
- The under-hood fuse/relay box is a part of the engine compartment wire harness, and it cannot be replaced by itself.
1
| Detailed information, notes, and precautions | |
| Torque: N.m (kgf.m, lbf.ft) | |
| Replace |
- PCM - Remove
- 12 Volt Battery Terminal - Disconnect
- Relay Circuit Board - Remove
- Relay Control Module - Remove
- Under-Hood Fuse/Relay Box - Remove
- Cable - Disconnect
- Fuse Block - Remove
- Bottom Covers - Remove
- Relays - Remove
1. Carefully remove the relays using the relay puller tool.
NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall, not start, or cause other functions to fail. - All Removed Parts - Install
1. Install the parts in the reverse order of removal.