Entering the Self-Diagnostic Function (Manual Method)

Before doing the self-diagnostic function, make sure the fuses and relays associated with the system, and check for a short in the related lines.

1. Press and hold the SEL/RESET knob.

2. Turn the combination light switch to the PARKING position.

Courtesy of HONDA, U.S.A., INC.

3. Turn the vehicle to the ON mode.

4. Within 5 sec., turn the combination light switch to OFF, then to the PARKING position and OFF again.

5. Within 5 sec., release the SEL/RESET knob, and then repeatedly press and release the knob three times.

Courtesy of HONDA, U.S.A., INC.

NOTE: 

• While in the self-diagnostic mode, the dashlights brightness controller operates normally.
• While in the self-diagnostic mode, the SEL/RESET knob is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
• If the vehicle speed exceeds 1.2 mph (2 km/h), or turn the vehicle to the OFF (LOCK) mode, the self-diagnostic mode ends.

Courtesy of HONDA, U.S.A., INC.