Removal and Installation

Where icon is shown, for further information continue to the information below.

1 

Fig 1: Intermediate Shaft Replacement Components With Torque Specifications

Courtesy of HONDA, U.S.A., INC.

	Detailed information, notes, and precautions
	Torque: N.m (kgf.m, lbf.ft)

1. Engine Undercover - Remove
2. Transmission Fluid - Drain
3. Right Driveshaft - Remove 
4. Intermediate Shaft Assembly - Remove

   NOTE:  Hold the intermediate shaft horizontally until it is clear of the differential to prevent damaging the oil seal.

5. All Removed Parts - Install

   1. Install the parts in the reverse order of removal.

6. Intermediate Shaft - After Install Check

   1. Turn the wheel by hand and make sure there is no interference between the driveshaft and surrounding parts.

7. Wheel Alignment - Check
8. Test Drive - Check