DTC C0061-62, C0062-62, C0063-62
DTC C0061-62 : Lateral Acceleration Sensor Failure (Signal Compare Failure)DTC C0062-62 : Longitudinal Acceleration Sensor Failure (Signal Compare Failure)DTC C0063-62 : Yaw Rate Sensor Failure (Signal Compare Failure)
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- The yaw rate-acceleration sensor is built into the SRS unit.
- Before troubleshooting, check the SRS unit for proper mounting. If not properly installed the VSA modulator-control unit may set these codes.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0061-62 Lateral Acceleration Sensor Failure (Signal Compare Failure) | ||
| C0062-62 Longitudinal Acceleration Sensor Failure (Signal Compare Failure) | ||
| C0063-62 Yaw Rate Sensor Failure (Signal Compare Failure) |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
-4. Test-drive the vehicle under these conditions:
- Vehicle speed at 31 mph (50 km/h) or more for at least 20 seconds
- Brake pedal released
- Change lanes for a few times
NOTE:
- Drive the vehicle on the road, not on a lift.
- Be careful of the surrounding traffic conditions.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0061-62 Lateral Acceleration Sensor Failure (Signal Compare Failure) C0062-62 Longitudinal Acceleration Sensor Failure (Signal Compare Failure) C0063-62 Yaw Rate Sensor Failure (Signal Compare Failure) Is DTC C0061-62, C0062-62, or C0063-62 indicated?
YES
The failure is duplicated. Replace the SRS unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.