DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, C001D-49
DTC C0010-49 : Inlet Solenoid (Left Front) Circuit Failure DTC C0011-49 : Outlet Solenoid (Left Front) Circuit Failure DTC C0014-49 : Inlet Solenoid (Right Front) Circuit Failure DTC C0015-49 : Outlet Solenoid (Right Front) Circuit Failure DTC C0018-49 : Inlet Solenoid (Left Rear) Circuit Failure DTC C0019-49 : Outlet Solenoid (Left Rear) Circuit Failure DTC C001C-49 : Inlet Solenoid (Right Rear) Circuit Failure DTC C001D-49 : Outlet Solenoid (Right Rear) Circuit Failure
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0010-49 Inlet Solenoid (Left Front) Circuit Failure | ||
| C0011-49 Outlet Solenoid (Left Front) Circuit Failure | ||
| C0014-49 Inlet Solenoid (Right Front) Circuit Failure | ||
| C0015-49 Outlet Solenoid (Right Front) Circuit Failure | ||
| C0018-49 Inlet Solenoid (Left Rear) Circuit Failure | ||
| C0019-49 Outlet Solenoid (Left Rear) Circuit Failure | ||
| C001C-49 Inlet Solenoid (Right Rear) Circuit Failure | ||
| C001D-49 Outlet Solenoid (Right Rear) Circuit Failure |
DTC (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
-4. Wait 20 seconds or more.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0010-49 Inlet Solenoid (Left Front) Circuit Failure C0011-49 Outlet Solenoid (Left Front) Circuit Failure C0014-49 Inlet Solenoid (Right Front) Circuit Failure C0015-49 Outlet Solenoid (Right Front) Circuit Failure C0018-49 Inlet Solenoid (Left Rear) Circuit Failure C0019-49 Outlet Solenoid (Left Rear) Circuit Failure C001C-49 Inlet Solenoid (Right Rear) Circuit Failure C001D-49 Outlet Solenoid (Right Rear) Circuit Failure Is DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, or C001D-49 indicated?
YES
The failure is duplicated. Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.