DTC B0050-F0 (VSA Control Unit)

DTC B0050-F0  : Driver's Seat Belt Buckle Switch Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (VSA)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Turn the vehicle to the ON mode, then wait for a few seconds or more.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   B0050-F0 Driver's Seat Belt Buckle Switch Malfunction

   Is DTC B0050-F0 indicated?

   YES 

   The failure is duplicated. Go to SRS troubleshooting .

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.