Brake System Inspection and Test: Inspection
- Brake System - Inspect
Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged.
Component Inspections:
Component Procedure Also check for Master cylinder Look for damage or signs of fluid leakage at: - Reservoir or reservoir grommets.
- Lines and their joints.
- Between master cylinder and brake booster.
Bulging seal at reservoir cap. This is a sign of fluid contamination. Brake hoses Look for damage or signs of fluid leakage at: - Line joints and banjo bolt connections.
- Hoses and lines, also inspect for twisting or damage.
Bulging, twisted, or bent lines. Caliper Look for damage or signs of fluid leakage at: - Piston seal.
- Banjo bolt connections.
- Bleed screw.
Seized or sticking caliper pins. VSA modulator-control unit Look for damage or signs of fluid leakage at: - Line joints.
- Modulator-control unit.